12-14-2001 02:34 AM - edited 03-12-2019 01:44 PM
I have to integrate a CCM with Active Directory, with 400 users. Is there a way to keep the profiles?
I did a test with integrating but then I loose all profiles, so the devices have to be associated with the users again (and CTI-use and....)!
Any Tips or idea's.
Regards,
Sascha
12-20-2001 01:03 PM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
12-21-2001 08:02 AM
To my knowledge there is no way around this issue. You will have to reassociate the users with there devices when you change the directory.
Thank you,
-Mckee
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide