Re: Active Directory Plugin - Subcriber installation error.
if you didn't set up dc-directory, these env-vars probably will be missing. but since the dcd gets installed in a default-instalation, there certainly went something wrong.
there are some env-vars concerning the dcd. the ones from a standard-installation are ( on my system ) :
maybe you try to set them manually via : controlpanel->system->(advanced-tab) environment-variables
here you can set these variables , but be sure to add them as a SYSTEM-envvar. after doing that, maybe the setup continues. another possiblity would be getting the dcd standalone- installation file ( tac will provide it hopefully ), and re-install the dcd.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.