I need the comma equivalent wildcard for Callmanager so I can add a delay before sending additional digits. If I remember correctly you cannot use commas, you have to use another wildcard like &,?, or $ or something.
To my knowledge, you can't natively add pauses in route patterns, translations, etc. within CallManager. Now you can in dial-peers, so depending on your needs you might be able to do something with a H.323 gateway. Link here:
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.