Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Add new E1

Hi,

I already have one E1(voice) running well (VWIC-2MFT-E1). I want now to use the second port of the VWIC card, what should i do next, to configure the seconde E1 as same as the first one??

#configure terminal

config)#controller e1 0

config-controlle)#pri-group timeslots 1-31

config)#isdn switch-type primary-net5

.....

is that all? what about dial peer..etc?

JayD

1 REPLY
Gold

Re: Add new E1

JayD,

You have to do the same configuration as with the first E1, and depends on your gonfiguration, H.323 or MGCP add new dial-peers for the voice ports.

If you are using H.323 you have to set up the 'preference' command in the new voice dial-peers in order to have more lines for outgoing calls.

If you are using MGCP you will have to set up in the callmanager the new E1 in the gaeway configuration and add a new dial-peer in the router configuration.

Hope this helps,

Juan Luis

145
Views
0
Helpful
1
Replies
CreatePlease login to create content