Right now I am working with a Cisco AS5300. We are terminating traffic to several carriers but we are having problems because we have only one E1. I had asked to my telephony provider for another E1. My problem is that I want my AS5300 to use that E1 when the other one is full . I know that wth ds0-group command you can match the pots peer with the controller E1 you want, but how can I configure the AS5300 to choose the other E1 when the first one is full.
I am sending a piece of my actual sh run (controller and pots peers)
Please can somebody help me with this ??
fax interface-type vfc
mta receive maximum-recipients 0
controller E1 0
clock source line primary
ds0-group 0 timeslots 1-15,17-31 type r2-digital r2-compelled ani
It will hunt over to the next E1 by default, but you can also give higher preference to your prefered PRI. Use preference 1 under the pots dial-peers for the first PRI and lower preference for your ner PRI link preference 5.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...