Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Adding CallManager to an NTP Network?

Is there anyway you know of to make CallManager look at an external NTP Server - my CallManager keeps losing time?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Adding CallManager to an NTP Network?

5 REPLIES
New Member

Re: Adding CallManager to an NTP Network?

Hello Stu,

1. Insure that NetworkTimeProtocol is running under WIN 2K service

2. In the c:\winnt\ntp.conf file enter the following:

Server A.B.C.D

Driftfile %windir%\ntp.drift

3. Stop and start the NetworkTimeProtocol service

A.B.C.D is the address of the NTP server.

Regards,

Bob

New Member

Re: Adding CallManager to an NTP Network?

Thanks Bob, I should have mentioned, does this work if the NTP server is a piece of network equipment (CAT6K) and not another W2K server?

Cisco Employee

Re: Adding CallManager to an NTP Network?

Hi Stu,

Yes, it will work if the NTP Server is a Network Equipment.

Muhilan

Cisco Employee

Re: Adding CallManager to an NTP Network?

New Member

Re: Adding CallManager to an NTP Network?

Cisco is using the same open source ntpd from www.ntp.org, excellent product. Search CCO for the Network Time Protocol documentation for CallManager -jason

136
Views
0
Helpful
5
Replies
CreatePlease login to create content