After Upgrade to 4.1(3) problem with QSIG

[j-lehmann]

Hello,

after an upgrade from 3.3(3)SR4a to 4.1(3)SR1 we have problems with QSIG function. It is not possible to see the Caller Name and Numbers from the other side of the qsig trunk. That means, comes a call from the HICOM via VG200 gateway with a new IOS and MGCP, side to the Callmanager side and vice versa, we see not the caller name and number.

HAve any body also that problem and a solution.

Befor we upgrade thats works fine.

King regards Joerg

[aamercado]

On the Route Pattern, do you have:

Calling Line ID Presentation

Calling Name Presentation

Connected Line ID Presentation

set to "allowed"

On the Portal Page,

http://www.cisco.com/warp/public/779/largeent/avvid/inter_operability/flash/portal.html

there's a doc on Hicom and it should cover callerid