Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

After Upgrade to 4.1(3) problem with QSIG

Hello,

after an upgrade from 3.3(3)SR4a to 4.1(3)SR1 we have problems with QSIG function. It is not possible to see the Caller Name and Numbers from the other side of the qsig trunk. That means, comes a call from the HICOM via VG200 gateway with a new IOS and MGCP, side to the Callmanager side and vice versa, we see not the caller name and number.

HAve any body also that problem and a solution.

Befor we upgrade thats works fine.

King regards Joerg

1 REPLY
Bronze

Re: After Upgrade to 4.1(3) problem with QSIG

On the Route Pattern, do you have:

Calling Line ID Presentation

Calling Name Presentation

Connected Line ID Presentation

set to "allowed"

On the Portal Page,

http://www.cisco.com/warp/public/779/largeent/avvid/inter_operability/flash/portal.html

there's a doc on Hicom and it should cover callerid

99
Views
0
Helpful
1
Replies
CreatePlease login to create content