Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AJ: 3640, Televantage and Digital T1

I have a 3640 router with a VWIC-2MFT-T1-DI card connected to an IP PBX (Artisoft Televantage) using an RJ48C cable. I assumed that my cable is now working since the LED in my PBX is already green. The PBX is already configured to route voice to the router when you dial 77. I also configured the router. To test if everything works Iift the handset, got a dialtone from the PBX, then I dial 77 and got a squeaky tone for 1 second and got back the tone from the PBX. Can anyone shed light on this one. Thanks a lot.

Here are the PBX specs:

Framing Type: D4 Superframe

Interface: DSX-1

Supervisory signal: 2- or 4-wire E&M

Wink: Wink and double wink

Line coding/Framing: AMI

Digit signaling: DTMF

DNIS Length: 4 digits

ANI: Yes

My router config:

---------------------

3640(config)# voice-card 2

3640(config-voice-card)# codec complexity high

3640(config)# controller T1 2/0

3640(config-controller)# framing sf

3640(config-controller)# linecoding ami

3640(config-controller)# clock source internal

3640(config-controller)# ds0-group 1 timeslots 1-24 type e&m-wink

3640(config-controller)# no shut

3640(config)# voice-port 2/0:1

3640(config-voiceport)# description *** connected to Televantage PBX ***

3640(config-voiceport)# cptone US

3640(config-voiceport)# no shut

3640(config)# dial-peer voice 101 pots

3640(config-dial-peer)# destination-pattern 7

3640(config-dial-peer)# port 2/0:1

3640(config)# dial-peer voice 102 voip

3640(config-dial-peer)# destination-pattern 6666

3640(config-dial-peer)# ip precedence 5

3640(config-dial-peer)# session target ipv4:192.168.1.2

1 REPLY
Bronze

Re: AJ: 3640, Televantage and Digital T1

I only suspect some signalling issue here. Try immediate start / delay start. It might help you.

http://www.cisco.com/cgi-bin/Support/browse/psp_view.pl?p=Internetworking:Telephony:Telephony_Signaling:Digital_CAS:E_M&s=Verification_and_Troubleshooting

More troubleshooting help on this can be found here.

106
Views
0
Helpful
1
Replies
CreatePlease login to create content