This is regarding a international toll bypass application with ulaw on one side and alaw on the other. For voice channel, i know i can use G.729 as the common codec on the IP trunk while T1 port and E1 port on either end programmed with ulaw and alaw accordingly. How about fax ? If I want to use fax passthrough, not fax relay, can I convert ulaw from T1 port into alaw in voip portion ? or there is another way to do it ?
no difference passthru/upspeed you will be common across the ip leg of the call and then conversion takes place on voice port there is no change in PCM stream received from pstn or sent to pstn. for instance
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...