cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
188
Views
0
Helpful
1
Replies

Alcatel Dec/t system, 6000 FXS module and call answer

simon.machielse
Level 1
Level 1

Hi,

At a customer site we have a Alcatel Dec/t system for the mobile phone connections across a factory.

We use Callmanager 3.1.2c and a 12 ports FXS module in a 6009 chasis.

The Alcatel system is connected to the analogue FXS module on the 6009.

The problem is when we ring an IP/analogue phone from a Dec/t phone everything is going ok. But when we call a Dec/t phone from an alalogue or IP phone the Alcatel Dec/t phone can pick up the call but the IP or analogue phone keeps on giving the normal "wait for answer tone", and the call is not being "picked up" at the Alcatel Dec/t phone.

IP 2 IP phone, analogue 2 IP phone and analogue to analogue phone work perfectly.

Does anyone have some experience in this problem ?

Can anyone advise me if we have to do some configuration changes on the Callmanager ?

Any ideas or suggestions are welcome !

Thanx in advance,

Simon

1 Reply 1

ciscomoderator
Community Manager
Community Manager

Often times complex troubleshooting issues are best addressed in an interactive trouble-shooting session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: