Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
apu
New Member

Alter caller ID on MGCP FXO port??

We have one PRI and four FXO ports at our main site and another five FXO ports at a secondary site. As configured, the FXO ports are MGCP ports normally and H323 in SRST mode.

Of course, since we cannot get Caller ID on an MGCP port, any call that comes in via an FXO port shows up as just "Unknown Number From External Caller." Can we change that message in anyway? The thought is to at least identify which line (FXO port) it came in over and display that info for the end user.

CallManager 4.1

5 REPLIES
Blue

Re: Alter caller ID on MGCP FXO port??

This should work:

voice-port 1/0/0

station-id name Line1

station-id number 5551212

apu
New Member

Re: Alter caller ID on MGCP FXO port??

Will that work with both MGCP and H323? FWIW, that's what we have configured already but it doesn't work -- at least under normal conditions - haven't tried SRST yet.

voice-port 0/3/1

timing hookflash-out 50

station-id name SITENAME

station-id number NPANXXXXXX

caller-id enable

Blue

Re: Alter caller ID on MGCP FXO port??

I thought it would, but all our FXOs use H323 with the SRST TCL script, so I wasn't sure.

You could route through a translation pattern, which would allow you to mask in a calling number, but you can't insert a name.

Cisco Employee

Re: Alter caller ID on MGCP FXO port??

Not sure if have the FXO-M1, but "FXO-M1 is an enhancement of FXO with battery reversal and Caller ID features". If you have the regular FXO, then caller id is not presented.

http://www.cisco.com/en/US/products/hw/routers/ps221/prod_bulletin09186a00800920e1.html#wp39257

apu
New Member

Re: Alter caller ID on MGCP FXO port??

We are using the VIC2-4FXO in a 2851 and another VIC2-4FXO in a 2821 (also has SRST).

254
Views
0
Helpful
5
Replies
CreatePlease to create content