Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

AMIS and unity dial ID

Do I necessary need to create a Dial ID if I only have one unity server and needs AMIS setup with the other voice system?Thanks

4 REPLIES
Gold

Re: AMIS and unity dial ID

Yes, the delivery location will need a dial ID. You can adjust it down to a lower number by editing HKLM\SOFTWARE\Active Voice\Doh\1.00\DWORD: 'Minimum Location AVP_DTMF_ACCESS_ID' but it will need to be at least 1 digit to work correctly.

Thanks,

Keith

New Member

Re: AMIS and unity dial ID

What about primary location? Do I need it in my case? I guess not, it looks it's only used when addressing blind message from other unity server.

Gold

Re: AMIS and unity dial ID

Correct, you don't need to set one.

Bronze

Re: AMIS and unity dial ID

To set up AMIS, you need to configure the Node ID on the primary location in the SA. As soon as you do this and try to save the page, the SA will prompt for a Dial ID, and won't let you save the page until you enter a Dial ID. When Unity sends an AMIS message, it transmits the Node ID on the primary location to identify itself as the sending system. I would imagine that most other voice mail systems would need to be configured in some fashion with the node ID that Unity sends to identify itself.

Nancy

114
Views
0
Helpful
4
Replies
CreatePlease to create content