Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

analog DID trunk config

I have a group of 2-Way analog DID trunks for a small office and am trying to config them to support both DID and to ring a DN that is configured for a hunt group in CME on a 2851 router. I am not certain if I am on the right track, but I created the following dial peers:

dial-peer voice 1 pots

destination-pattern .T

incoming called-number .

direct-inward-dial

port 0/1/0

dial-peer voice 2 pots

destination-pattern .T

incoming called-number .

direct-inward-dial

port 0/1/1

dial-peer voice 3 pots

destination-pattern .T

incoming called-number .

direct-inward-dial

port 0/1/2

dial-peer voice 4 pots

destination-pattern .T

incoming called-number .

direct-inward-dial

port 0/1/3

dial-peer voice 5 pots

destination-pattern .T

incoming called-number .

direct-inward-dial

port 0/2/0

and I created plar statements on all of the FXO voice ports to point to 1429, which is my hunt group DN:

voice-port 0/1/0

connection plar opx 1429

voice-port 0/1/1

connection plar opx 1429

voice-port 0/1/2

connection plar opx 1429

voice-port 0/1/3

connection plar opx 1429

voice-port 0/2/0

connection plar opx 1429

Am I on the right track? What else do I need to configure to get this working?

Thanks

Rob

1 REPLY
Silver

Re: analog DID trunk config

Your configuration look good. Make sure the direct-inward-dial command is not configured under the dial-peer voice pots command. This is not supported on analog Foreign Exchange Office (FXO) and Foreign Exchange Station (FXS) cards. Direct-Inward-Dial (DID) is only supported on Voice Interface Card (VIC)-DID cards. If DID is configured on the normal FXO and FXS cards, it can disable the dial tone and usually returns a fast busy signal.

1702
Views
0
Helpful
1
Replies