Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ANI send over T1

Hello everyone, I am not too familiar with the T1 signaling, but I have made some test over a T1 for passing the ANI, and seems that it isn't working.

I'm using the next configuration

controller T1 1

framing esf

clock source line secondary 1

linecode b8zs

ds0-group 1 timeslots 1-24 type e&m-fgb dtmf dnis

but it seems that doesn't want to work. I'm also using pots dial peer and translation rules for terminating the calls through this T1,

any clues?

Thanks

3 REPLIES
Silver

Re: ANI send over T1

If you want to have ANI pass through the circuit, you will need to configure the circuit for fgd, which involves a dual wink and you will have to make sure your telco is provisioned for that as well. fgd-eana and e&m-fgd are assymetrical, so make sure you know which direction you want the ANI to go.

New Member

Re: ANI send over T1

Thanks for those tips, let me check that too. I had to change the IOS on the box (5300) from a 12.2(7c) to a 12.2(15T), and it worked better, still using e&m-fgd mf ani-dnis

New Member

Re: ANI send over T1

Hello everyone. Finally it worked with the next config:

controller T1 1

framing esf

clock source line secondary 1

linecode b8zs

ds0-group 1 timeslots 1-24 type fgd-eana mf ani-dnis

and also had to configure on the dial-peer and on the voice port the

calling-number outbound range XXXX

command. Thanks for your tips and answers

88
Views
3
Helpful
3
Replies
CreatePlease to create content