Sorry for alot of questions on the 1861. I am trying to do some work on our new device but I am finding that it did not ship with SDM installed. Is there a reason for this? This is not suppored with CCA yet correct? How can I (or should I) add SDM to this?
You make a very good point however some of the configurations produced with SDM are over 200 lines long :) for us small shops its sure nice to use it as a framework :)... with that said is there a reason SDM is not installed? I hear conflicting things that the 1861 could possibly be managed with CCA .. I tested with CCA 1.6 and had a no go. As this is a cross-over product of sorts I want to make sure I have the right answer.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...