Is there any way to configure SRST to wait a specified amount of time before allowing phones to re-register with CCM? I have a flapping WAN link that is becoming a problem because the phones failover into SRST mode but because the link comes back up the phones re-home to CCM as soon as the link is back up. Then the process begins again 10 minutes later and causes more problems.
I have tried the CCM-Manager Switchback uptime command, but this did not do what I was hoping for.
When SRST is invoked, I want it to stay in place for at least 15 minutes regardless of the WAN link coming back up or not.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...