Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Anyone got a HICOM 300E integrated with CM?

Am looking for some setup help on a HICOM 300E using PRI to a VG200 gateway. We initially setup T1 between the two and it worked fine. Having some PBX config issues with PRI however.

  • Other Collaboration Voice and Video Subjects
3 REPLIES
Cisco Employee

Re: Anyone got a HICOM 300E integrated with CM?

You might want to try your luck in the IP Telephony forum. This forum is specific to Unity voice mail systems.

New Member

Re: Anyone got a HICOM 300E integrated with CM?

I have one customer that connects to a Seimen's HICOM 300E via PRI off a Cat6K 6608 T1 module. They have been using this config for almost 2 years.

Since there was no Qsig support, we had to configure the protocol as NI2.

Talk to your local Cisco SE, as there is a whitepaper available on how to configure both sides in a HICOM integration.

Bronze

Re: Anyone got a HICOM 300E integrated with CM?

Hi,

this is a interoperability document for 2621 with Siemens Hicom.

http://www.cisco.com/application/pdf/en/us/guest/products/ps266/c1237/ccmigration_09186a00800e70e6.pdf

hope this helps

mehmet

100
Views
0
Helpful
3
Replies
This widget could not be displayed.