Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Application and QoS

Hi friends,

I have a question for you.

I work with an application that runn over telnet protocol. I have a link with 2 Mb BW, and I need that this application only uses a 50% of 2 MB=1MB, but I have others application that are prioritaries over this telnet application, so, if others application need to use more BW that 1 MB, can use without problems. How can Implement it? Which QoS feature can I use?

Regards and Thank you very much

1 REPLY

Re: Application and QoS

You will want to use traffic policing to limit the bandwidth used by telnet. This is done by creating a class-map that matches telnet traffic, creating a policy-map that polices traffic in the class map and assigning the policy-map to an interface with the service-policy command. Take a look at the following link.

http://www.cisco.com/en/US/products/sw/iosswrel/ps5014/products_feature_guide_chapter09186a00800ca4f2.html

Hope this helps. If so, please rate the post.

Brandon

102
Views
0
Helpful
1
Replies
CreatePlease login to create content