Often times complex troubleshooting issues are best addressed in an interactive trouble-shooting session with one of our trained technical assistance engineers. While other forum users may be able to help, its often difficult to do so for this type of issue.
i have the same kind of problem with c7200-p-mz.121-9.E. The difference is that my policy-map works when i have bandwidth statement but does not work if there is priority instead bandwidth. In your case i think the problem might be that 80+40 is very close to 128 which is total bandwith. Try to decrement these a bit or use bandwidth percent.
Before applying the service-policy command to interface, do a 'term mon' in exec mode (not config mode). If you're close on QoS bandwidth exceeding available bandwidth there will be a error displayed across console when the service-policy is applied about not enough bandwidth.
80+40 - 120. Your VBR is set to 282, but there is a bandwidth command set to 128. So the above is probably occurring. 75% of 128 is 96. You can use the max-reserved-bandwidth interface command to change default of 75% to higher if needed but be careful.
I believe you can't apply policies without specific routers and parameters. I believe the 7200 can directly apply QOS for certain interfaces. If you can't, I believe you have to use either virtual bundles or virtual templates.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.