Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

AS 5350 trouble

Subscriber is connected to the AS through the AudioCodes gateway.

The AudioCodes is connected to the FE through IP network.

When subscriber trying to dial some nubmer on the analog station, which after the AS, the connection is established but it drops after about 3 minutes...

Analog station is connected to the E1 3/0:

!

controller E1 3/0

framing NO-CRC4

pri-group timeslots 1-21

!

Here is the log:

484 : 17232463hs.18880 +-1 +18270 pid:48 Answer 2277609

dur 00:00:00 tx:8618/170004 rx:9115/182300 66 (recovery on timer

expiry(102))

IP 10.10.64.3:4000 rtt:33ms pl:24000/130ms lost:10/20/10 delay:60/60/130ms

g729r8

media inactive detected:n media contrl rcvd:n/a timestamp:n/a

484 : 17232467hs.18881 +1071 +18267 pid:111111 Originate 2259453

dur 00:02:51 tx:9103/182060 rx:8618/170004 66 (recovery on timer

expiry(102))

Telephony 3/0:D (19808): tx:177260/17000/0ms g729r8 noise:-57dBm acom:90dBm

The full config is in attachement.

Please! Try to help me, the subscribers is complained...

Thanks a lot!

2 REPLIES
New Member

Re: AS 5350 trouble

Probably the problem is in signalling?

New Member

Re: AS 5350 trouble

Maybe this help:

VoIP_5350#sh isdn status Serial3/0:15

Global ISDN Switchtype = primary-net5

ISDN Serial3/0:15 interface

dsl 0, interface ISDN Switchtype = primary-net5

Layer 1 Status:

ACTIVE

Layer 2 Status:

TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED

Layer 3 Status:

7 Active Layer 3 Call(s)

CCB:callid=6833, sapi=0, ces=0, B-chan=11, calltype=VOICE

CCB:callid=683A, sapi=0, ces=0, B-chan=17, calltype=VOICE

CCB:callid=F5B1, sapi=0, ces=0, B-chan=19, calltype=VOICE

CCB:callid=F5B3, sapi=0, ces=0, B-chan=21, calltype=VOICE

CCB:callid=6849, sapi=0, ces=0, B-chan=18, calltype=VOICE

CCB:callid=684B, sapi=0, ces=0, B-chan=20, calltype=VOICE

CCB:callid=F5B6, sapi=0, ces=0, B-chan=13, calltype=VOICE

Active dsl 0 CCBs = 7

The Free Channel Mask: 0x80006BFF

Number of L2 Discards = 0, L2 Session ID = 30

Total Allocated ISDN CCBs = 7

VoIP_5350#sh contr E1 3/0

E1 3/0 is up.

Applique type is Channelized E1 - balanced

No alarms detected.

alarm-trigger is not set

Version info of slot 3: HW: 517, PLD Rev: 1

Framer Version: 0x8

Manufacture Cookie Info:

EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x0A,

Board Hardware Version 2.5, Item Number 73-5268-02,

Board Revision B0, Serial Number JAE07050BSE,

PLD/ISP Version , Manufacture Date 31-Jan-2003.

Framing is NO-CRC4, Line Code is HDB3, Clock Source is Line.

Data in current interval (335 seconds elapsed):

0 Line Code Violations, 0 Path Code Violations

0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs

Data in Interval 1:

0 Line Code Violations, 0 Path Code Violations

0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs

Data in Interval 2:

0 Line Code Violations, 0 Path Code Violations

0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs

Data in Interval 3:

0 Line Code Violations, 0 Path Code Violations

0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs

.

.

.

Data in Interval 96:

0 Line Code Violations, 0 Path Code Violations

0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs

Total Data (last 24 hours)

0 Line Code Violations, 0 Path Code Violations,

0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,

0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs

VoIP_5350#sh isdn timers

ISDN Serial3/0:15 Timers (dsl 0) Switchtype = primary-net5

ISDN Layer 2 values

K = 7 outstanding I-frames

N200 = 3 max number of retransmits

T200 = 1.000 seconds

T202 = 2.000 seconds

T203 = 10.000 seconds

ISDN Layer 3 values

T301 = 180.000 seconds

T303 = 4.000 seconds

T304 = 30.000 seconds

T305 = 30.000 seconds

T306 = 30.000 seconds

T307 = 180.000 seconds

T308 = 4.000 seconds

T309 Disabled

T310 = 40.000 seconds

T313 = 4.000 seconds

T316 = 120.000 seconds

T318 = 4.000 seconds

T319 = 4.000 seconds

T322 = 4.000 seconds

T3OOS = 5.000 seconds

TGUARD= 8.000 seconds, Expiry = REJECT_CALL

T-activate = 4.000 seconds

*** dsl 1 is not configured

.

.

.

136
Views
0
Helpful
2
Replies
CreatePlease to create content