Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AS5300 as back-up for AS5350

Hi , We are starting up a VoIP network using AS5350 as PSTN GW and 827-4V as endpoints. Is it an option to have an AS53500 as back up in case of failure of the AS5350. Could we use the same config ?

Thanks

2 REPLIES
New Member

Re: AS5300 as back-up for AS5350

If your attention is to create automatic fail over from the AS5350 to As5300 please provide more information as for the call-signaling that you are using.

Assuming that you want to have AS5300 ready for case of emergency and all you have to do is to switch T1 then the answer to your question is yes,

But:

1. You have to pay attention to your IOS version; As5300 requires upgrading the Vcware DSP component in separate.

2. The controller and the Serial numbering system is different

Other then that both IOS supports the same IOS features/ commands.

Regards

New Member

Re: AS5300 as back-up for AS5350

Yrap

Thanks a lot for your answer . We are thinking of the emergency case where we just need to move the PSTN connection to the AS5300 .

Jerry

85
Views
0
Helpful
2
Replies
CreatePlease login to create content