Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AS5300 as gateway and VG200 as transcoder problem

Hi,

we have two sites with WAN connectivity and G.729. In first we are using AS5300 as gateway to PSTN. On second we have ATA166. ATA doesn't support G.729 on both ports so we would like to use VG200 as transcoder. On second site there is R1751 as backup connection to PSTN too.

But we have problem with VG200 and AS5300. We sure that we have configured it well, we test it with R1751. Transcoder works well, have correct route, is able to ping to all phones, CCM, AS5300.

When we debuged (debug sccp all, debug dspfarm all), we see that CCM trying to send call to transcoder. It gets it but then it fails. We used packet sniffer and we see that CCM forgeting to send one sccp command to transcoder. When we using R1751 as gateway, all works fine.

Does have anyone working AS5300 and VG200 together?

Jirka Novak

4 REPLIES
Bronze

Re: AS5300 as gateway and VG200 as transcoder problem

I'm a little unsure of your topology and requirement. Can you please be little more elaborate?

New Member

Re: AS5300 as gateway and VG200 as transcoder problem

So, there is diagram:

Locality A:

AS5300

Locality B:

R1750 (12.2(11)T)

ATA boxes

IP phones

XCODE (VG200) (12.1(5)YH4)

CM

Calls A <-> B are made by G.729, but ATA can have G.729 only on first port. On second it is able G.711 only. So we would like to use XCODE. But we had problems with it.

We transfer R1750 to Loc A and configure it same way as AS5300. It works with XCODE fine.

We captured packets between CM and XCODE in all cases. We found that when CM managing call AS5300->XCODE->ATA it sends two skinny messages in one packet (and XCODE fails). But when CM managing R1750->XCODE->ATA it sends same two skinny messages in two packets and it works fine.

Two skinny messages are OpenReceiveChannel and StartMediaTransmition.

Bronze

Re: AS5300 as gateway and VG200 as transcoder problem

I would suggest you to check for any failure cause by enable the traces on the call manager and see why transcoding fails.

You can also check out http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_technical_reference_chapter09186a00800c2f78.html and also

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_technical_reference_book09186a00800c2f71.html to aid in troubleshooting this problem

New Member

Re: AS5300 as gateway and VG200 as transcoder problem

Hi

I trying to find any document of how to configuring Gateway 2650/VG200/1751

to work as XCODE.

can you send me a document about it or show running config in your gateway?

thanks

gal ofri

galo@bezeq-call.co.il

111
Views
0
Helpful
4
Replies
CreatePlease login to create content