Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AS5300 voice config

the other side can hear me but i can not hear anything at all.

trying to see what we can configure on the other side to send a stronger signal.

2 REPLIES
New Member

Re: AS5300 voice config

I have had problems with ip addresses in the dial peers where one side is sending the RTP stream to the wrong port. check all the Voip Dial-Peers destanation patterns

New Member

Re: AS5300 voice config

i will check the codec settings on the Voip dial peers. Also check the byte sizes if both ends are using the same codec type. I found that to be the most common source of the problem. a sniffer will be very helpful in this case.

102
Views
0
Helpful
2
Replies
CreatePlease to create content