i have a 3-AS5300 scenario in a hub&spoke topology running VoIP between them, what we want to do is to make calls from one spoke to another, but passing through the central site for billing issues. I think I can do this using a gateKeeper, but i think I can not use the AS5300 as Gatekeeper, just as a Gateway.
i configure on spoke#1 to direct all the calls to the cental site IP address, and also configure the central site to "redirect" these calls to spoke#2 IP address using a voip dial-peer.
It is something like this (dp=dial-peer):
spoke#1 pots dp (origin) ---> spoke#1 voip dp ---> central voip dp ---> spoke#2 pots dp
Hi, i think that you want use this gateway as terminator/originator for all your calls, this function of re-originate is not supported for cisco gateway. To make this you need a h323 proxy solution or the use of two ports (port 1 for terminate on this gateway connected directly to port 2 for re-originate the call to IP network).
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.