ASK THE EXPERT- GATEWAY AND GATEKEEPER: H323 (VOIP, VOFR), ITS/SRST AND TCL
I would like to ask you a question about an scenario of GK.
I have a client who has an AS5300 voip GW. I have also an AS5300 working as voip GW and a C2600 working as a GK. My client doesn't want to register his GW to my GK, and I don't want to send traffic GW to GW. So I would like to know If there is any way to register staticaly the route of my client GW in my GK so I could send traffic to him through it ?.
I read in Cisco documents about the alias static command but I could not make it work in my GK. If there is a way to do this I would be very gratefull if you could post me an example of the route and how to make my gateway ask for that route in my GK.
Where 192.168.1.1 is the ip address of the endpoint, cisco is the name of the local zone, 192.168.1.2 is the address of the gatekeeper, 1234 is the e164 served by this gateway and cisco.com is the domain of the local zone of the gatekeeper.
After this do a show gatek end and you should see it in there.
Re: ASK THE EXPERT- GATEWAY AND GATEKEEPER: H323 (VOIP, VOFR), I
I had done that...
But when I dial the e164 number from other GW that is registered in my GK (in order to reach that GW) it fails the call. (it dont even appear in the sh ga call commands). CAn you tell me how to set the route in order to reach that GW ???
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.