Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ATA 186 2 ports calling

Hi !

ATA 186 with 2 ports witn newest software could make 2 calls simoulteniously.

My settings are next :

LBRCodec: 0

RxCodec: 0

TxCodec: 0

ATA186 is registered with 3640 Gatekeeper and after

that calls are routed to my providers gateway.

Providers gateways supports all possible codecs.

They have defined voice class with all codecs,

G723g53, G723g, etc.

It is critical to make ATA186 calling simoulteniously from both ports.

Any ideas, suggestions, configs ?

Thanks,

Alexander

1 REPLY
New Member

Re: ATA 186 2 ports calling

I have made a point to point connection between two ATA-186 units (so, no GK in the play). I could make two simultaneous calls (G.723.1 - LBRCodec=RxCodec=TxCodec=0). I think this will not help you any much, but that's the result I have so far. The datasheet says it can't support two concurrent G.729A calls though.

By the way, in the near future, I'll have to go for a GK. I wonder whether it was tricky or easy for you to configure the 3640 to deal with the ATA-186.

Thank you,

Paulo

p.borelli@ipredia.com.br

117
Views
0
Helpful
1
Replies