Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ATA-186 - bandwidth ?

Hi,

I would like to use the ATA-186 for IP telephony,

However, my band width between the two nodes (ATA-186) will be 192 Kbps, and I'll need most bandwidth to my uses.

How much bandwidth will the ATA-186 take for voice and is it possible to limit it to a specific bandwidth 8/16Kbps ?

If not, would you recommend using it or maybe there is some other solution.

Thanks

Vago Guy

2 REPLIES
Cisco Employee

Re: ATA-186 - bandwidth ?

Off of this URL-

http://www.cisco.com/warp/public/788/voip/ata_gatekeeper.html

You will see what codecs the ATA can use. Then this URL will tell you how much BW each codec requires-

http://www.cisco.com/warp/public/788/pkt-voice-general/bwidth_consume.html

So it depends on what codec you use.

New Member

Re: ATA-186 - bandwidth ?

Thanks a lot

thats really clear things up

86
Views
0
Helpful
2
Replies