Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATA-186, can they be config without CCM or gateway?point to point??

Hello all,

I find my self with two ata-186's that I would like to use from one ip network -- through the internet --- to the other ip network. Ca. to Hi. thought it be fun to set up. Can this be done WITHOUT Callmanager or a Gateway server. Can it be done with just IOS ??

Thanks,

Phil

2 REPLIES
New Member

Re: ATA-186, can they be config without CCM or gateway?point to

This is possible with all h.323 gatekeeper or gateway (IOS IS GATEKEEPER AND GATEWAY).

Have open H.323 for linux , this work same form IOS Gateway or Gatekeeper.

Is possible you connect both ata186 over internet if all stay connect to open h.323.

Joao Medeiros

Systems Engineer

Brazil

Re: ATA-186, can they be config without CCM or gateway?point to

Sure can. Using the H323 firmware, just point the gateway entries on each ATA to the IP address of the other unit. Then just dial the number assigned to the other unit.

95
Views
0
Helpful
2
Replies
CreatePlease to create content