I need to set Phone 1 port on a ATA Connect Mode bit=7 to 1 to enable RFC2198 (packet redundancy) on the 2811ISR we have enabled voice service voip, with g711ulaw redundancy to overcome a fax not working all the time;
If I got my translation right, I should enter into the ATA Connect Mode;
Re: ATA 186 Connect Mode to enable RFC 2198 on line1
It is unlikely that configuring redundancy is going to resolve the issue. What is the AudioMode parameter currently set to? How is the voice gateway currently configured? The following from the voice gateway would be helpful.
show controllers t1 (if there's a T1 voice circuit)
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...