cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
280
Views
0
Helpful
1
Replies

ATA 186 ringing different when internal calls

hguttesen
Level 1
Level 1

Is it possible to change the setting that causes the ATA186 to ring differently when it is an internal call.

The problem is that we use an analog bell that rings perfectly when you ring from an eksternal number, but when you ring from an internal phone, the ring cadance is not enough to trigger the bell apperently.

Hope you can help...

Heini Guttesen, Denmark

1 Reply 1

wojtek
Level 1
Level 1

Hi

I am not sure if it is possible to change ringing tone for ATA with SCCP software. Look at:

http://www.cisco.com/univercd/cc/td/doc/product/voice/ata/ataadmn/sccp3_0/sccpaape.htm#wp1029585

there is not anything about ring tone.

You can try to change your ATA software from SCCP to H.323, and for H.323 there is possible to change ring tone frequency and cadence:

http://www.cisco.com/univercd/cc/td/doc/product/voice/ata/ataadmn/h32330ad/h3288ape.htm#wp1055597

At this time you should configure your ATA in CCM as a H.323 gateway, and send calls to it via route-pattern. You still will be able to configure ATA extensions as On-Net or Off-Net.

Hope that this help.

Regards

Wojtek

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: