Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATA 186 ringing different when internal calls

Is it possible to change the setting that causes the ATA186 to ring differently when it is an internal call.

The problem is that we use an analog bell that rings perfectly when you ring from an eksternal number, but when you ring from an internal phone, the ring cadance is not enough to trigger the bell apperently.

Hope you can help...

Heini Guttesen, Denmark

1 REPLY
New Member

Re: ATA 186 ringing different when internal calls

Hi

I am not sure if it is possible to change ringing tone for ATA with SCCP software. Look at:

http://www.cisco.com/univercd/cc/td/doc/product/voice/ata/ataadmn/sccp3_0/sccpaape.htm#wp1029585

there is not anything about ring tone.

You can try to change your ATA software from SCCP to H.323, and for H.323 there is possible to change ring tone frequency and cadence:

http://www.cisco.com/univercd/cc/td/doc/product/voice/ata/ataadmn/h32330ad/h3288ape.htm#wp1055597

At this time you should configure your ATA in CCM as a H.323 gateway, and send calls to it via route-pattern. You still will be able to configure ATA extensions as On-Net or Off-Net.

Hope that this help.

Regards

Wojtek

137
Views
0
Helpful
1
Replies
CreatePlease to create content