I was wondering if there is documentation regarding the 2 mac addresses that pop up for the 2 lines when you auto register. Where does the second mac come from. I tried to put another phone on the 2nd mac but it would not function. Has anyone had success with having to phones on one adapter? When we tried to get them to work recently and a while ago, only one line would work at a time.
When you use an ata186 with 2.15ms software it will have a seperate phone entrie for each line. The second line uses a mac address with the first two digits stripped and 01 at the end and is build from the original mac address of the ata.
If you do an auto-reg both lines should work fine.
I haven't checked caveats. For us it works fine with 3.2.2c-SPe or SPf
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...