Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Silver

ATA 186

Hi,

I have CallManager 3.1 and 6608 is my gateway to PBX. I'm trying to connect a fax to ata 186 but I dont see a way to configure it on the gateway. Will it work only with a router ??

Thanks

Marina

5 REPLIES
New Member

Re: ATA 186

My understanding of the 6608 is that its MGCP connected, so controlled by Call Manager - see http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/cfgnotes/78_10972.htm#xtocid154292 . So all the voice connection details are in the CCM configuration. The ATA is just another H323 Gateway. So I'd expect to point the ATA at CCM as its default gateway having configured its DN and the supporting elements in the Dial Plan of CCM.

Silver

Re: ATA 186

Hi,

Thats exactly what I did.Analog phones work fine but if I want to connect a fax I need to make an additional configuration on the gateway I think.Am I wrong?

New Member

Re: ATA 186

Are you trying to configure two different phone numbers for the two analog ports on the ATA186. I did this by creating two different route patterns point to the h323 gateway that i created early.

New Member

Re: ATA 186

You Mean the difference between fax passthru and fax relay? I take it you are looking at the "fax rate" commands on IOS and the local handling of the setup of the fax negotiation. I think some input from Cisco is required here, since I understand that ATAs are supported under CCM 3.2

Silver

Re: ATA 186

Does it mean i have to wait for CCM 3.2 to use ata 186 with 6608 ? :(

Thanks for your help by the way

111
Views
0
Helpful
5
Replies
CreatePlease login to create content