Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ATA Auto-Registration

I am running CM3.2.2c. I have ATA adapters that have 2.14ms for the firmware and the ATAs are configured with dhcp. After the 2 lines on the ATAs are set up with the device names ATAXXXXXXXXXXXX, eventually an SEPXXXXXXXXXXXX device name will show up with a new auto-registered number for the same adapter and will bring the 1st configuration offline. Is there a resolution or documentation on this issue?

Thank you.

3 REPLIES
New Member

Re: ATA Auto-Registration

These links below may be of use to you if you haven't seen them already....

How to Configure Cisco CallManager to Recognize ATA 186 Using SCCP

http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_configuration_example09186a00800a892f.shtml

Cisco ATA 186 FAQ and Common Issues

http://www.cisco.com/warp/public/788/voip/ata-faq.shtml

New Member

Re: ATA Auto-Registration

If I recall correctly CCM 3.2.2C ---- ATA186 runs with 2.15.

Cisco Employee

Re: ATA Auto-Registration

Sounds like CSCdx88821. Also I remember an issue with this in code prior to 2.15 so you may want to delete the devices and try again with the latest ATA code.

132
Views
0
Helpful
3
Replies
CreatePlease to create content