ATA config to prevent registration attempt of non active port

[tredgrove]

I want to prevent unused ATA analogue ports from attempting to register and clogging up log files with failed attempts. I know there is more than one option but, i believe it can be done by entering a "dot" in the line field - maybe in conjunction with some other steps. Can anyone expand on this or have i imagined this process? Tks.

[Rob Huffman]

Hi Tony,

Here is the process;

Note By default, both Cisco ATA FXS ports are enabled for Cisco CallManager registration. If you do not want to add the Phone 2 FXS port to Cisco CallManager, you must change the Cisco ATA EPID1orSID1 parameter value to 0 to disable the Phone 2 port. (To disable the Phone 1 port, you must change the EPID0orSID0 parameter value to 0.)

http://www.cisco.com/en/US/docs/voice_ip_comm/cata/186_188/2_15_ms/english/administration/guide/sccp/sccpach4.html#wpxref70796

http://www.cisco.com/en/US/docs/voice_ip_comm/cata/186_188/2_15_ms/english/administration/guide/sccp/sccpaape.html#wp1020682

http://www.cisco.com/en/US/docs/voice_ip_comm/cata/186_188/2_15_ms/english/administration/guide/sccp/sccpaape.html#wpxref65796

Hope this helps!

Rob

[mwild]

this worked for me.

Copy the ip address of the ATA into your web browser, then go to the SCCP Parameters and change SID1 from a . to a /