Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATA config to prevent registration attempt of non active port

I want to prevent unused ATA analogue ports from attempting to register and clogging up log files with failed attempts. I know there is more than one option but, i believe it can be done by entering a "dot" in the line field - maybe in conjunction with some other steps. Can anyone expand on this or have i imagined this process? Tks.

2 REPLIES
Hall of Fame Super Red

Re: ATA config to prevent registration attempt of non active por

Hi Tony,

Here is the process;

Note By default, both Cisco ATA FXS ports are enabled for Cisco CallManager registration. If you do not want to add the Phone 2 FXS port to Cisco CallManager, you must change the Cisco ATA EPID1orSID1 parameter value to 0 to disable the Phone 2 port. (To disable the Phone 1 port, you must change the EPID0orSID0 parameter value to 0.)

http://www.cisco.com/en/US/docs/voice_ip_comm/cata/186_188/2_15_ms/english/administration/guide/sccp/sccpach4.html#wpxref70796

http://www.cisco.com/en/US/docs/voice_ip_comm/cata/186_188/2_15_ms/english/administration/guide/sccp/sccpaape.html#wp1020682

http://www.cisco.com/en/US/docs/voice_ip_comm/cata/186_188/2_15_ms/english/administration/guide/sccp/sccpaape.html#wpxref65796

Hope this helps!

Rob

New Member

Re: ATA config to prevent registration attempt of non active por

this worked for me.

Copy the ip address of the ATA into your web browser, then go to the SCCP Parameters and change SID1 from a . to a /

145
Views
10
Helpful
2
Replies