Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATA Disconnect Issue

My customer has an analog intercom system at their front gate. When the button is pressed the call rings an extension in CCM. I have this working - the analog intercom is connected via an ATA & I use a blank translation pattern to simulate PLAR functionality.

Now when the gate intercom button is pressed an internal extension rings.

My problem being that when my internal extension hangs up, the analog intercom is not closing the line & continues to dial the internal extension.

Now the "supervisory disconnect" issue affects FXO & my ATA is FXS - does this mean that the problem is with the remote analog intercom device ?

Is there any solution I can provide from the CCM side (4.1(3)sr2) ?

TIA.

132
Views
0
Helpful
0
Replies
CreatePlease to create content