Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

ATA drop the call after 120 sec.

i have CCM3.2.2a and more ATA.

when the phone connected to ATA started a call, after 120 sec the call is disconnected!

ideas?

4 REPLIES
Cisco Employee
New Member

Re: ATA drop the call after 120 sec.

the problem is only on ATA, and the ipphone (7940-60) work fine.

the voice gateway is c3640 with 6 BRI (basic-net3) on VIC-2BRI-NT/TE card.

thanks.

New Member

Re: ATA drop the call after 120 sec.

Hi , I had the same problem . Have a look at your StationKeepaliveInterval , this should be set to 30 seconds .

Regards

New Member

Re: ATA drop the call after 120 sec.

thanks!

I suspected this timeout!

now i have select the default timeout and i don't have the problem.

bye

100
Views
5
Helpful
4
Replies
CreatePlease to create content