Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ATA in SRST

Folks,

We have a special need. We have a big warehouse which have IP Phones in it. We want the following:

In SRST mode the main number should ring the night bell or over head paging system.

At the same time someone should be able to pick up that call. I was looking at the documentation for "call-pickup" in SRST mode.

I found out that the phone has to be a e-phone for it to be pickup by another phone through call pickup when it is ringing.

Right now over head paging or night bell are connected to a FXS port and call pickup in SRST does not work. I tried to connect the night bell to ATA and see if it works in SRST since ATA registers with the SRST router, but that did not help either.

I noticed that the ATA registers with the SRST router, but i do not see it get a number or keep it's original number when I type in "show ephone" in router when it is SRST mode.

Does anyone know why?

Thanks

2 REPLIES
Silver

Re: ATA in SRST

New Member

Re: ATA in SRST

Thanks for the doc. What i am trying to do it is a follows:

in SRST mode when i call comes in it should go to night bell connected via(FXS or ATA). While the bell is ringing people should be able to pick up the phone and answer the call(call picup in SRST). Is that possible?

I was hoping that i could use ATA deviced since call pickup in SRST only works with ephones and fxs would not be an ephone. But the problem i am having is that the ata does not show extension in SRST even though it registers with the router. does anyone know why?

158
Views
0
Helpful
2
Replies