We have a special need. We have a big warehouse which have IP Phones in it. We want the following:
In SRST mode the main number should ring the night bell or over head paging system.
At the same time someone should be able to pick up that call. I was looking at the documentation for "call-pickup" in SRST mode.
I found out that the phone has to be a e-phone for it to be pickup by another phone through call pickup when it is ringing.
Right now over head paging or night bell are connected to a FXS port and call pickup in SRST does not work. I tried to connect the night bell to ATA and see if it works in SRST since ATA registers with the SRST router, but that did not help either.
I noticed that the ATA registers with the SRST router, but i do not see it get a number or keep it's original number when I type in "show ephone" in router when it is SRST mode.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.