Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ATA186 - 2 Extensions possible?

Running CCM 4.02, have ata186's. Can't seem to create a button template for ATA to allow 2 extensions. ATA's have two phone ports, but can they only be programmed with one extension?

2 REPLIES

Re: ATA186 - 2 Extensions possible?

Each ATA port registers with Callmanager as a separate phone, so you would need to assign an extension to each phone. The first port has the MAC address of the ATA. The MAC for the second port is derived by dropping the 2 left-most digits of the ATA MAC and adding 01 to the right. Take a look at the ATA admin guide for confirmation.

http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_administration_guide_chapter09186a00800c4d1b.html

Hope this helps. If so, please rate the post.

Brandon

Re: ATA186 - 2 Extensions possible?

Apart from what Brandon said, if you let autoreg on on the server, both ports should register.

128
Views
0
Helpful
2
Replies
CreatePlease to create content