Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATA186 and DTMF

Hi,

I´m using ATA-186 Boxes for a Gate-Application.

You can phone a internal phone and this phone can open the door.

Also you can open the door with a code.

The supplier for this systems said, it will be done by dtmf.

I tried the lastest version fo the ATA-software but none of the settings will work.

The settings were in audio mode: 0x00050005, 0x00150015 and 0x00250025

The solution is within the LAN, so we have no GW-configs to make.

Any ideas?

re. August

1 REPLY

Re: ATA186 and DTMF

I have something similar with alarm panels all on ATAs (all had their GW pointing to a central unit). Below are my key settings using the H323 firmware. It's been a while, so I don't recall all of the bits and what they did. One of them disabled dtmf relay and carried it as voice. Make sure you're using G711

AudioMode: 0x00020002

ConnectMode: 0x00008010

RxCodec: 2

TxCodec: 2

-Chris

126
Views
0
Helpful
1
Replies