Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ATA186 and Tech-Prefix

Hello,

We are using tech-prefix to call between our VOIP routers and gatekeepers. At this moment we have ATA186 at remote location. ATA186 is connected to our VOIP network through gatekeeper.

The question is becomes, how to assign tech-prefix 10# to the ATA186 ?

Any ideas ?

We can't change our network to don't use tech-prefix ...

Thanks

1 REPLY
New Member

Re: ATA186 and Tech-Prefix

Hi,

In your GK, enter

"gw-type-prefix 10# gw ipaddr IP_ADDREESS_OF_ATA" command under gatekeeper configuration mode.

If you use more than two zones in your GK, enter

"gw-type-prefix 10# hopoff ZONE_OF_ATA gw ipaddr IP_ADDREESS_OF_ATA".

ERDEM...

94
Views
0
Helpful
1
Replies
CreatePlease to create content