Does anyone have a config for the ATA186 and Call Manager using MGCP? I've tried Cisco's website but to no avail. I'm about to give up and go back to H.323. Any reason why I should pick H.323 over MGCP?
The ATA186 registers with CCM as H323. Simple setup...make sure you give it an IP address/mask, static route to GW. The Gateway entry is the CallManager. UID0 and UID1 are the DNs in CCM. Hope this helps
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...