Hi. We'are using some ATA186 boxes in IOS Telephony Service environment (known also as keyswitch) with MGCP/SCCP software v2-14-ms (Build 020514a) on ATAs. After upgrading software on ATAs to v2-15-ms (Build 020723a) we got some problems with registration, ATA reports another device type to IOSTS (was 7 - 7960, with 2-15ms - 12). IOSTS doesn't know this device type, but register ATA186 with error "Unknown 12" and doesn't assign lines to ATA. After downgrading to 2-14ms on ATA and reassigning lines everything works again. I've tryed two builds: 020722a and 020723a. Not sure about correct registration with CM3.0/3.1, didn't try. I have no active contract now, that's why ask on this conference.
You could go back to the old code that registered properly otherwise you'll probably need to get a support contract from Cisco to see if there is a bug they need to work on for you. With this technology, support contract are well worth the money.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...