Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ATA186, SCCP - select port g.729a capable

Hi.

How can I select port on ATA186, which can use g.729 codec. By default it's port 0. Bit 21 is used only in MGCP mode.

Thanks.

3 REPLIES
Bronze

Re: ATA186, SCCP - select port g.729a capable

2.12 (or higher) supports g.729a the best (there were some bugs in 2.11) but I’m almost positive you can’t select any other port than 0 (Check with Cisco to be sure). Settings are: LBRCodec: 3, LBRCodec: 3, RxCodec: 3, TxCodec: 3, AudioMode: 0x00140014

Community Member

Re: ATA186, SCCP - select port g.729a capable

Do you mean h323/sip software ? I know, how change g.729 capable port in this software, but I was asking about MGCP/SCCP software.

Bronze

Re: ATA186, SCCP - select port g.729a capable

I couldn’t find anything in the docs on that. You’ll prob have to check with Cisco on that.

122
Views
0
Helpful
3
Replies
CreatePlease to create content