02-09-2003 02:21 AM - edited 03-12-2019 10:37 PM
Hi all,
I have ATA186 working with CCM3.2 i Skkiny protocol,
both line are registered , but one of the lines apear as ATAXXXXXXXXXXXX
and the other SEPXXXXXXXXXXXX.
Is it the default or is it a wrong configuration?
Is there any way to make them appear as ATAXXX.. on both line?
Thanks.
02-09-2003 05:20 AM
from this URL:
I see this:
Use the following procedure to add the second port on the Cisco ATA 186 to CallManager.
Drop the first 2 nibbles of the MAC address and shift the MAC address to the left, then add 01 to the right end of the MAC address.
For example 00070EA26032 is port 1 and 070EA2603201 is port 2.
Use this new MAC address from above and start over at step 4.
Hope that helps!
02-09-2003 11:31 AM
Hi,
As Crieman said, you have to install the ATA manually.
Our experience with the ATA:
Always use latest softwareversion,
not use auto registration, because sometimes the ATA-18x will be recognized as 7960 phone and then there are two entries in the CM.
1) ATA
2) 7960
regards
August
02-12-2003 04:18 AM
Thanks you all,
could you tell me if you had any problem to set its ports to Fax?
i would appreciate any tip. I have CCM 3.2.
Thanks, again kito
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide