Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ATA186 with CCM 3.2 in Skkiny - 1 line is ATA186 other is 7960?

Hi all,

I have ATA186 working with CCM3.2 i Skkiny protocol,

both line are registered , but one of the lines apear as ATAXXXXXXXXXXXX

and the other SEPXXXXXXXXXXXX.

Is it the default or is it a wrong configuration?

Is there any way to make them appear as ATAXXX.. on both line?

Thanks.

3 REPLIES
Cisco Employee

Re: ATA186 with CCM 3.2 in Skkiny - 1 line is ATA186 other is 79

from this URL:

http://www.cisco.com/en/US/partner/products/hw/gatecont/ps514/products_configuration_example09186a00800a892f.shtml

I see this:

Use the following procedure to add the second port on the Cisco ATA 186 to CallManager.

Drop the first 2 nibbles of the MAC address and shift the MAC address to the left, then add 01 to the right end of the MAC address.

For example 00070EA26032 is port 1 and 070EA2603201 is port 2.

Use this new MAC address from above and start over at step 4.

Hope that helps!

New Member

Re: ATA186 with CCM 3.2 in Skkiny - 1 line is ATA186 other is 79

Hi,

As Crieman said, you have to install the ATA manually.

Our experience with the ATA:

Always use latest softwareversion,

not use auto registration, because sometimes the ATA-18x will be recognized as 7960 phone and then there are two entries in the CM.

1) ATA

2) 7960

regards

August

New Member

Re: ATA186 with CCM 3.2 in Skkiny - 1 line is ATA186 other is 79

Thanks you all,

could you tell me if you had any problem to set its ports to Fax?

i would appreciate any tip. I have CCM 3.2.

Thanks, again kito

99
Views
0
Helpful
3
Replies
CreatePlease to create content