Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATA186 with SCCP and IOS Telephony Service

Hi.

I'm trying to use ATA186 (SCCP software) with keyswitch (ITS v2.0). I got working only one port of ATA with keyswitch. Is it possible to get working port2?

Thanks.

3 REPLIES

Re: ATA186 with SCCP and IOS Telephony Service

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Bronze

Re: ATA186 with SCCP and IOS Telephony Service

You have to configure 2 7960 phones in callmanager. One with the correct MAC address for port 1 and one with a slightly different MAC address for port 2.

If the ATA's MAC address is say 00021d59e334 then add the second phone with a MAC of 021d59e33401. In other words for the second MAC address, take the first MAC address, delete the first 2 digits and add 01 to the end.

I know this sounds crazy, but I just got 4 of these working today.

New Member

Re: ATA186 with SCCP and IOS Telephony Service

Thanks.

I've already read it on cco (release notes for MGCP/SCCP software).

105
Views
0
Helpful
3
Replies